Effort3 min read

What is training to failure? It means RIR 0

Training to failure means stopping a set only when you can't finish another clean, full-range rep: 0 reps in reserve. Orion Coach never programs it.

By Published Last updated

The short answer

Training to failure means continuing a set until you cannot finish another full-range rep with your normal form, which is 0 reps in reserve (RIR 0). Orion Coach never programs it: its sets mostly aim for 2 reps in reserve, so failure is your choice, and logging it usually drops your next set one weight step.


Training to failure is RIR 0: the next rep won't go up through full range in your normal form. Stopping when the burn peaks, with one clean rep left, is RIR 1.

What is training to failure?

Refalo et al. (2023) define momentary muscular failure as the first rep you can't lift through full range without breaking form. Orion Coach uses the same definition of training to failure.

RIR 0 equals RPE 10 (Zourdos et al., 2016).

Past the beginner stage, Orion uses double progression, not failure sets. See also more reps or more weight.

Technical, absolute and eccentric failure

If you choose to go there, stop at technical failure. These are coaching labels, not research definitions.

  • Technical: reps slow, then one stalls.
  • Absolute: it won't move, even cheating.
  • Eccentric: you can't lower it under control.

Coach Orion's call

I never program a set to failure. Most of the working sets I write aim for 2 reps in reserve, some for 3 and a few for 1. None aim for 0. Going to failure is your choice, and if you go there, I want to know.

When you log a set with the "0 Failure" chip, I read it as harder than I asked for. On your next set I drop one weight step (5 lb per hand on dumbbells). If you're past the beginner stage, I also reset you to the bottom of your rep range. As a beginner, you keep your single rep target. For the rest of that session I won't put you back above that lighter weight. One rep in reserve against my target of 2 is different: I hold the weight. Rack top-set programs follow their own rule.

That's my approach, not a law of training. The research suggests strict failure gives no clear growth edge, and sets that stop short give me a cleaner read on how strong you are.

I don't treat failure as the goal, and one failure set doesn't decide your next session alone. I plan that session from your average RIR across the lift's working sets. So log your best honest guess. If you could have ground out one more clean rep, that was RIR 1, not 0.

Worked example

A walkthrough of how Orion applies this rule, not a real user's data.

  • Starting state: dumbbell seated overhead press, 30 lb per hand, rep range 8 to 12, target 2 reps in reserve, 3 working sets today, intermediate lifter.
  • Set 1: 10 reps, logged RIR 2. That's on target and inside the range, so set 2 asks for 11 reps at 30 lb.
  • Set 2: the lifter chooses to push. Rep 11 stalls halfway, so the set counts as 10 reps, logged with the "0 Failure" chip.
  • The signal: RIR 0, which is 2 reps harder than the target of 2.
  • The decision: set 3 drops one step to 25 lb per hand and resets to 8 reps, the bottom of the range. The lift stays at 25 lb or lighter for the rest of the session.
  • Compare: if set 2 had been logged RIR 1 instead, set 3 would hold at 30 lb for 10 reps.
  • Next session: planned from the average RIR across all three sets, not from the failure set alone.

What the evidence doesn't tell us

Refalo et al. (2023) suggest failure gives at most a trivial growth edge, but its studies were mostly short and in untrained lifters. Self-ratings miss by about 1 rep on average (Halperin et al., 2022).

Frequently asked questions

Is RIR 0 the same as training to failure?
Yes. RIR 0 means you couldn't have done another clean, full-range rep, which is technical failure, and Helms et al. (2016) treat an RIR of 0 as training to failure. Grinding on with cheat reps goes past it.
What is the difference between technical failure and absolute failure?
Technical failure is the first rep you can't finish with full range and good form. Absolute failure is when the weight won't move at all, even if you cheat. These are coaching labels, and Steele et al. (2017) suggest research terms for set endpoints have been ambiguous.
Does Orion Coach ever program sets to failure?
No. No weighted set in its 60-program library targets RIR 0. Most target RIR 2, some RIR 3 and a few RIR 1, so going to failure is the lifter's choice.
What happens in Orion Coach if I log a set as RIR 0?
It counts as harder than planned. Your next set drops one load step (5 lb per hand on dumbbells) and, for intermediate and advanced lifters, resets to the bottom of the rep range (beginners keep their single rep target). The lift stays at that lighter weight or below for the rest of the session. Rack top-set programs follow their own rule. Your next session is planned from your average RIR across the lift's working sets, not from one set.
How do I go to failure on dumbbell bench press without a spotter?
Pick a lift you can bail from. If a dumbbell rep stalls, lower the weights to your chest and drop them out to the sides. Avoid going to failure on a barbell bench or squat with no safeties, and log the set honestly as RIR 0.

Sources

  1. Refalo MC, Helms ER, Trexler ET, et al. (2023). Influence of Resistance Training Proximity-to-Failure on Skeletal Muscle Hypertrophy: A Systematic Review with Meta-analysis. Sports Medicine.
  2. Zourdos MC, Klemp A, Dolan C, et al. (2016). Novel Resistance Training-Specific Rating of Perceived Exertion Scale Measuring Repetitions in Reserve. Journal of Strength and Conditioning Research.
  3. Helms ER, Cronin J, Storey A, Zourdos MC (2016). Application of the Repetitions in Reserve-Based Rating of Perceived Exertion Scale for Resistance Training. Strength and Conditioning Journal.
  4. Steele J, Fisher J, Giessing J, Gentil P (2017). Clarity in reporting terminology and definitions of set endpoints in resistance training. Muscle & Nerve.
  5. Halperin I, Malleron T, Har-Nir I, et al. (2022). Accuracy in Predicting Repetitions to Task Failure in Resistance Exercise: A Scoping Review and Exploratory Meta-analysis. Sports Medicine.

Orion Coach puts this into practice for you. Real-time, recovery-aware strength coaching on your iPhone.

Try Orion Coach free: 14 days, no card