Progression6 min read

Missed reps on a set? What to do next session

Missed reps? Judge the effort, not the count. At failure or more than 1 rep harder than planned, drop one load step (5 lb per hand). Otherwise, hold.

By Published Last updated

The short answer

Judge a missed set by effort, not the rep count. If your working sets average failure or more than 1 rep harder than your target reps in reserve, start next session one load step lighter (5 lb per hand on dumbbells) at the bottom of the range (on beginner programs, back to your prescribed reps); otherwise, keep the weight.


After missed reps, usually hold the weight. In one trial of 5 sets at a 15-rep-max load, rep counts fell from the first set to the fifth whether lifters rested 30 seconds or 2 minutes (Willardson and Burkett, 2006), so a short last set is often just fatigue.

What should I do if I miss reps on a set?

The rep count tells you what happened. The reps in reserve you log tell you why. Orion Coach reads both against the target it set for that lift, usually 2 in reserve:

  • Failure, or more than 1 rep harder than the target: drop one load step and go back to the bottom of the rep range (on beginner programs, back to your prescribed reps).
  • About 1 rep harder than the target: hold the weight and repeat the reps you just did. That's normal fatigue. Next session, if your average was inside the range, Orion usually asks for one more rep at that weight.
  • Below the bottom of the range at the target effort or easier: hold the weight and chase the floor next time.
  • Missed mid-set: don't rest briefly and retry the missing reps. Log the set as it happened and let the next set or session adjust.

Orion makes these calls set by set during a workout, and plans next session from your session average. That's autoregulation. For how the range climbs when sessions go well, see double progression.

How big is one load step?

One step is a fixed jump for each kind of equipment:

  • 5 lb per hand on dumbbells
  • 5 lb on a barbell, or 2.5 lb if you own microplates, and only weights your recorded plates can make
  • 10 lb on a pulley

It's never a percentage, and never more than one step, however big the miss. After a step down, your working sets can't exceed last session's count. The full rule is on how Orion progresses you.

Why effort, not the rep count

Research supports the idea behind the rule. It hasn't tested the exact numbers.

  • A reps-in-reserve scale tracked bar speed in both experienced and novice squatters, which suggests it's a practical way to set the day's load (Zourdos et al., 2016).
  • The authors of a practical guide to the RIR scale recommend lowering the load when a lifter can't complete the planned reps in sets prescribed at 0 to 1 RIR, and raising it when sets come in with more than 1 rep to spare (Helms et al., 2016). They give no amount to drop.
  • In an exploratory meta-analysis of 12 studies and 414 participants, people underpredicted their reps to failure by 0.95 reps on average, and were slightly more accurate close to failure (Halperin et al., 2022).
  • Adjusting load to effort builds strength about as well as fixed loading. A meta-analysis of 6 studies and 133 trained lifters found no significant 1RM difference (Hickmott et al., 2022). In an 8-week trial, an RPE group made similar gains to a percentage group, with a possible small strength edge that was not statistically significant (Helms et al., 2018).
  • A set that hits failure isn't a bonus set. Across 15 studies, training to failure suggests at most a trivial hypertrophy edge over stopping short (Refalo et al., 2023).

Coach Orion's call

After each set I compare your reps in reserve with my target (what reps in reserve means): failure, or 2 or more reps harder than I asked, drops one weight step for your next set, while one rep harder is normal fatigue and holds (rack top-set programs run their own rule).

A missed set and a missed session are different calls. On its own, a rough set changes only your next set. For next session it's one set in an average: I average reps and reps in reserve across your working sets. If that average lands at failure or more than 1 rep harder than my target, you start one step lighter, at the bottom of the range (on beginner programs, back to your prescribed reps). If it's within a rep of target, the weight doesn't drop, even if your last set fell short.

Why average? Reps fall off across sets at the same weight, and lifters' guesses of reps left run about one rep off. One set can mislead me.

Why one step? Studies find adjusting load to effort works about as well as fixed loading, but none I found tests how much to drop after a miss. So 5 lb per hand is my call. A bigger miss never earns a bigger drop, and I never cut by a percentage.

If you chose a heavier weight than I prescribed, next session I keep it, with reps reset to the range bottom. A rough recovery morning never lowers your weight.

Worked example: one rough session on a bent-over row

A walkthrough of how Orion applies this rule, not a real user's data.

  • Starting state: DB Bent-Over Row, 45 lb per hand, rep range 5 to 7, target 2 reps in reserve, 4 working sets, intermediate lifter (Orion Coach's Strength 4-day Intermediate program). 45 lb is what I prescribed today.
  • Sets 1 to 3: 7 reps, then 6, then 5, each logged at RIR 1. Each set is one rep harder than the target, so after each one I hold 45 lb and ask you to repeat the reps you just did.
  • Set 4: 3 reps, logged "0 Failure". That's two reps under the bottom of the range, on the last set.
  • The signal: the session averages 5 reps, at the bottom of the range, but well under 1 rep in reserve against a target of 2. That's more than 1 rep harder than I asked.
  • The decision: next session is 40 lb per hand at 5 reps, target 2, and no more than the 4 working sets you did today. It's one step, however far 3 fell below 5.
  • Contrast: sets of 6, 6 and 6 at RIR 2, then 4 at RIR 0, average 1.5 in reserve, within a rep of target. The weight holds at 45 lb and next session asks for 7 reps.
  • Exception: if I had prescribed 40 lb and you chose 45 lb, with at least one set's reps in reserve logged, the same four sets would hold you at 45 lb next session with reps reset to 5, not cut you back to 40.

When missed reps mean something bigger

One stalled lift isn't a deload signal. Orion calls an early deload only when 2 of 3 signals stack across your training, and sets running harder than planned is just one of them. The details are in when to take a deload week and the deload rule.

If a bad night or a hard week is behind the miss, see should you change your workout on a bad recovery day. On your heaviest dumbbells, see the dumbbell ceiling.

What the evidence doesn't tell us

We found no study comparing how much to drop after a miss, whether to judge one set or the session average, or whether a fixed step beats a percentage cut. Most of the trials here used barbells, and several studied only young, trained men, so nothing is specific to dumbbells or older lifters. Reps in reserve is a self-rating that typically runs about a rep off.

This is general fitness information, not medical advice. If you have an injury or a medical condition, talk to your doctor or a qualified professional before changing your training.

Frequently asked questions

Should I retry the missed reps after a short rest?
No. Log the set as it happened and move on. The next set, or the next session, makes the adjustment.
Is getting fewer reps on each later set normal?
Yes. In a controlled trial, rep counts fell from the first set to the last at the same weight, with rests of 30 seconds to 2 minutes (Willardson and Burkett, 2006). Judge later sets by reps in reserve, not by whether they match the first set's count.
How much weight should I drop after missing reps?
One load step: 5 lb per hand on dumbbells, 5 lb on a barbell (2.5 lb with microplates) or 10 lb on a pulley. Never a percentage, and a bigger miss doesn't earn a bigger drop.
What if I missed reps because I went heavier than the app told me?
If the session would otherwise call for a step down and you logged reps in reserve on at least one set, Orion Coach keeps your heavier weight next session with reps reset to the bottom of the range.
When do missed reps mean I need a deload?
Not from one lift. Orion calls an early deload only when 2 of 3 signals stack across your training, and sets running harder than planned is only one of them. Our post on when to take a deload week covers the full rule.

Sources

  1. Zourdos MC, Klemp A, Dolan C, et al. (2016). Novel Resistance Training-Specific Rating of Perceived Exertion Scale Measuring Repetitions in Reserve. Journal of Strength and Conditioning Research.
  2. Helms ER, Cronin J, Storey A, et al. (2016). Application of the Repetitions in Reserve-Based Rating of Perceived Exertion Scale for Resistance Training. Strength and Conditioning Journal.
  3. Halperin I, Malleron T, Har-Nir I, et al. (2022). Accuracy in Predicting Repetitions to Task Failure in Resistance Exercise: A Scoping Review and Exploratory Meta-analysis. Sports Medicine.
  4. Willardson JM, Burkett LN (2006). The effect of rest interval length on the sustainability of squat and bench press repetitions. Journal of Strength and Conditioning Research.
  5. Helms ER, Byrnes RK, Cooke DM, et al. (2018). RPE vs. Percentage 1RM Loading in Periodized Programs Matched for Sets and Repetitions. Frontiers in Physiology.
  6. Hickmott LM, Chilibeck PD, Shaw KA, et al. (2022). The Effect of Load and Volume Autoregulation on Muscular Strength and Hypertrophy: A Systematic Review and Meta-Analysis. Sports Medicine Open.
  7. Refalo MC, Helms ER, Trexler ET, et al. (2023). Influence of Resistance Training Proximity-to-Failure on Skeletal Muscle Hypertrophy: A Systematic Review with Meta-analysis. Sports Medicine.

Orion Coach puts this into practice for you. Real-time, recovery-aware strength coaching on your iPhone.

Try Orion Coach free: 14 days, no card